milktriada.blogg.se - 2016 equinox brakes

This would be something to look at if there was no fluid leak detected. A shoe that is worn down too far will cause the pedal to sink closer to the floor than it normally would. There will never be a drum brake on front of a modern vehicle. If you hit the brakes a few times and the pedal hardens up, that indicates some air is trapped in the lines or that the fluid is bad.īrake shoes are only found on drum brake equipped vehicles. When this happens you’ll get a soft pedal that can go toward the floor. If the color is way off, that indicates that it should be changed.īrake fluid can go bad for a number of reasons. Compare it to some new fluid that Chevy recommends for your Equinox. The best way to check this is to pull a little out with a medicine dropper. When this happens it gets darker in color. Don’t give up until you find it.īrake fluid can go bad just like any other fluid. Keep in mind that if the master cylinder is low on fluid, that fluid has to be going somewhere. If there is, that’s proof positive that it needs replaced.

Inspect the master cylinder to see if there is fluid leaking from it.

It’s always on the firewall right about where you would expect it to be in relation to the brake pedal on the other side. When it goes bad, it loses pressure causing the brake pedal to go to the floor. The master cylinder is the part of the braking system that presses the fluid into the caliper or brake shoes. Bad Master Cylinder Typical Master Cylinder This is a very common point of brake failure.Ģ. If it is a drum brake look at the wheel cylinder. It’s likely to have a leak at the caliper seals at the piston(s).

If it’s a disc brake in question, inspect the caliper.

Always use a jack stand for safety reasons.

Jack up the vehicle and remove the wheel in question.

It’s much more likely that the problem is with a caliper or wheel cylinder. It’s highly unlikely that a brake line itself is bad. You should see fluid on the ground by one of them.

Pump the brakes for a few minutes with the Equinox’s engine running (check the fluid level from time to time, always put the lid on the master cylinder, you don’t want more air entering the system).

Fill the brake reservoir back up with the appropriate brake fluid for your vehicle.

If you’ve recently had brake work done, and the pedal is going further to the floor than it used to, you may need to bring it back to the shop and have the brake system bled.

It’s highly likely there is a leak, which you’ll need to find. This is due to the fluid in the lines being replaced by air whenever it leaks out. If the brake fluid is low, filling it back up is not going to fix the problem. All you have to do is take the lid off of the master cylinder reservoir and check the fluid level. It also happens to be the easiest to check. Items 3, 4, and 5 are reasons why the pedal could sink to the floor with no leak at all.Ī brake fluid leak is one of the most common reasons that the brake pedal would go to the floor. Items 1 and 2 are what you want to look at if there is a brake leak. If the vehicle still can stop, it’s not guaranteed that the problem won’t get worse.Įquinox Brake Pedal Goes to Floor: Causes + Diagnosisīelow we have listed five common reasons why your Chevy Equinox’s brake pedal may be hitting the floor. We don’t recommend driving anywhere with a brake system that is compromised. If any part of this system goes bad, the brake pedal can go to the floor. The brakes are a hydraulic system that takes the energy that you exert on your Equinox’s brake pedal, multiplies it via the brake booster, and uses it to stop the vehicle. We’ll go further into depth on each below. When the pedal goes to the floor, it’s usually caused by a bad master cylinder, leaking brakes, bad brake shoes (if equipped with rear drums), and a few other reasons. If your brake pedal is going to the floor, it indicates that there is a serious problem in the braking system. The single most important safety feature in your Chevy Equinox is a good set of brakes.